basic configuration the Mikrotik

Before configuring the IP addresses and routes please check the /interface menu to see the list of available interfaces. If you have Plug-and-Play cards installed in the router, it is most likely that the device drivers have been loaded for them automatically, and the relevant interfaces appear on the /interface print

[admin@MikroTik] interface> print
Flags: X - disabled, D - dynamic, R - running
 #    NAME                         TYPE             RX-RATE    TX-RATE    MTU
 0  R ether1                       ether            0          0          1500
 1  R ether2                       ether            0          0          1500
 2 X  wavelan1                     wavelan          0          0          1500
 3 X  prism1                       wlan             0          0          1500
[admin@MikroTik] interface>

The interfaces need to be enabled, if you want to use them for communications. Use the /interface enable name command to enable the interface with a given name or number, for example:

[admin@MikroTik] interface> print
Flags: X - disabled, D - dynamic, R - running
 #    NAME                         TYPE             RX-RATE    TX-RATE    MTU
 0 X  ether1                       ether            0          0          1500
 1 X  ether2                       ether            0          0          1500
[admin@MikroTik] interface> enable 0
[admin@MikroTik] interface> enable ether2
[admin@MikroTik] interface> print
Flags: X - disabled, D - dynamic, R - running
 #    NAME                         TYPE             RX-RATE    TX-RATE    MTU
 0  R ether1                       ether            0          0          1500
 1  R ether2                       ether            0          0          1500
[admin@MikroTik] interface>